Tatibandh, Raipur, Chhattisgarh
GST No. 22AAXFR2275F1ZZ
Approx. Rs 1.35 Lakh / NumberGet Latest PriceProduct Details:
|Minimum Order Quantity||1 Number|
|Installation Service Needed||No|
|System Version||WINDOWS 10|
SCR urea pump controller is perfectly compatible with Windows and Android operating system. The test software can be installed on any Windows and Android device. SCR urea pump controller can automatically identify the connected test equipment, and can turn on/off this function in the system settings,Available in two form factors.
A)Standby Urea pump will stop function test in standby mode
B)Pre injection pressure build-up After clicking the "pre-injection pressure" button, the SCR controller will carry out the operation of air evacuation and pressure establishment in the pipeline.
C)Clean (purge) After testing, before dismantling the urea pipeline, you need to click the "Clean (Purge)" button. The SCR controller will control the urea pump to perform the cleaning operation, and the urea pump and urea solution in the pipeline will be purged into the urea box.
D)Large/Medium/Small Flow Injection After successful pressure building, click "large flow injection", "medium flow injection" and "small flow injection" to observe the injection of urea solution.
1Component testing Component testing can only be done in standby mode SCR V1.00 11 2Message hint Display error, warning, prompt and fault information, etc. 3.Nitrogen and Oxygen Sensor Testing
1)After connecting the oxynitride sensor, click the "Start" button to start the test. Nitrogen and oxygen sensors will be heated first. After about one minute, they will be heated to a certain temperature and stop heating. The oxygen concentration and nitrogen oxide concentration around the sensor will be SCR V1.00 12 measured. The whole testing process is 5 minutes. 2)Whether the nitrogen and oxygen sensor is damaged or not can be judged according to the measured "oxygen concentration (%)" and "NO x (ppm)". In air environment, the oxygen concentration is about 20%, and the range of NO x ppm is 0-30. Note: When testing the nitrogen and oxygen sensor, it will be heated automatically. It is strictly forbidden to touch the metal part of the sensor to avoid scalding. Do not splash water or liquid on the sensor to avoid damaging the sensor 4.Measurement of Liquid Level/Temperature
Explore More Products